Metabo HPT DS 18DSDL Manual De Instrucciones página 13

The L-side of the selector button is pushed to turn the
bit counterclockwise (See Fig. 7). (The
marks are provided on the body.)
Trigger
switch
marks
○ When the trigger switch is depressed, the tool rotates.
When the trigger is released, the tool stops.
○ The rotational speed of the drill can be controlled by
varying the amount that the trigger switch is pulled.
Speed is low when the trigger switch is pulled slightly
and increases as the trigger switch is pulled more.
CAUTION
The push button can not be switched while the
power tool is turning. To switch the push button,
stop the power tool, then set the push button.
○ When releasing the trigger of the switch, the brake will
be applied for immediate stopping.
5. Change rotation speed.
Shift knob
Work
Brick
(DV18DSDL)
Wood
Drilling
Steel
Aluminum
Small screw
Screw
tightening
Wood screw
and
marks
Selector
button
Fig. 7
Low speed
Fig. 8
Cap position
1 – 22
1 –
High speed
Operate the shift knob to change the rotational speed.
Move the shift knob in the direction of the arrow (See
Figs. 8 and 9).
When the shift knob is set to "LOW", the drill rotates at
a low speed. When set to "HIGH", the drill rotates at a
high speed.
CAUTION
● When changing the rotational speed with the
shift knob, confi rm that the switch is off .
Changing the speed while the motor is rotating
will damage the gears.
● When a large force is required for operation
(operations indicated in the following chart) set
the shift knob to "LOW". If "HIGH" is set and the
unit is used, it may cause the motor to burn out
or malfunction prematurely.
6. The scope and suggestions for uses
The usable scope for various types of work based
on the mechanical structure of this unit is shown in
Table 4.
Table 4
Use for drilling purpose
Use for drilling purpose.
Use the bit and socket matching the screw diameter.
Use after drilling a pilot hole.
Shift knob
Fig. 9
Suggestions
English
13