Bosch 0603B03200 Manual Original página 48

OBJ_BUCH-783-003.book Page 47 Thursday, November 19, 2009 4:24 PM
– Turn the handwheel until the angle indicator
56 indicates the requested bevel angle on
the scale 57.
– Tighten the locking knob 29 again.
For quick and precise setting of the standard
angles 90° and 45°, end stops are given at the
housing.
Adjusting the Parallel Fences
Parallel Fence 8 (see figure E)
The mark in the lens 58 indicates the set clear-
ance of the parallel fence to the saw blade on
the scale 13.
– Position the parallel fence on the requested
side of the the saw blade. (also see "Mount-
ing the Parallel Guide", page 44)
– Pull the clamping knob 46 upward to release
the lock and move the parallel fence until the
lens 58 indicates the requested clearance to
the saw blade.
– To lock the parallel guide, press the clamping
knob 46 down.
Parallel Fence 10 at the Table Width Enlarge-
ment (see figure F)
The parallel fence 10 can be positioned either
left or right from the table width enlargement 9.
The colour of the sticker on the parallel fence
corresponds with the colours of the scale 59 on
the front guide rod. Depending on the position
of the parallel fence, the scale indicates the
clearance to the saw blade.
– Screw the parallel fence at the requested po-
sition to the table width enlargement.
– Grasp the table width enlargement centrally
and from below, and pull it out until the
green or yellow scale indicates the requested
clearance to the saw blade.
Bosch Power Tools
Adjusting the Auxiliary Parallel Guide
When sawing narrow workpieces and for bevel
cuts, the auxiliary parallel fence (aluminium) 18
must be mounted to parallel fence 8.
(see figure g2)
When sawing short workpieces, these can be-
come jammed between the parallel guide and
the saw blade, be caught by the rotating saw
blade, and be thrown from the machine.
Therefore, adjust the auxiliary parallel guide in
such a manner that its guiding end is located be-
tween the front saw blade tooth and the saw
blade centre.
– For this, loosen fastening knobs 48 and move
the auxiliary parallel fence 18 accordingly.
– Tighten the fastening knobs again.
When sawing high, narrow workpieces, the
auxiliary parallel fence (aluminium) 18 must be
mounted directly to parallel fence 8.
(see figure g3)
Starting Operation
Switching On (see figures G1–G2)
– Push the red EMERGENCY OFF button 14
leftward and open the yellow safety flap 30.
– To start the operation, press the green ON
pushbutton 60.
– Afterwards, shut the safety flap without en-
gaging it.
Switching Off (see figure G3)
– Press the red EMERGENCY OFF button 14.
Power Failure
The ON/OFF switch is a so-called non-voltage
switch, which prevents the power tool from re-
starting after a power failure (e. g., when the
mains plug is pulled during operation).
To restart the operation of the machine after-
wards, the green ON pushbutton 60 must be
pressed again.
1 609 929 T49 | (19.11.09)
English | 47