EGO PSA1000 Manual Del Usuario página 15

6. Place the chain drive links into the
guide-bar groove. Position the chain
so there is a loop at the back of the
guide bar (Fig. 4).
7. Hold the chain in position on the
guide bar and place the loop around
the sprocket of the pole saw.
NOTICE:
Small directional arrows
are engraved in the saw chain. Another
directional arrow is molded into the tool
body (Fig. 5a). When looping the saw
chain onto the sprocket, make sure that
the direction of the arrows on the saw
chain will correspond to the direction of
the arrow on the tool body. If they face
in opposite directions, turn over the saw
chain and guide bar assembly (Fig. 5b).
8. Place the guide bar on the mounting
surface by sliding the guide-bar slot
over the alignment bulges, making
sure that the tension-adjusting pin is
inserted in the lower hole in the tail
of the bar (Fig. 5a).
NOTICE:
If there is difficulty in inserting
the tension-adjusting pin into the hole,
adjust the chain-tensioning screw
properly until the tension-adjusting pin is
located exactly in the hole.
9. Replace the chain-sprocket cover, insert the cover-screw assembly through its
mounting hole, and then lightly tighten the chain-sprocket cover-screw by turning
it clockwise. The bar must be free to move for tension adjustment.
CAUTION:
NOTICE:
To extend the guide bar life, invert the bar occasionally.
POLE SAW ATTACHMENT — PSA1000/PSA1000-FC/PSA1020/PSA1020-FC
The saw chain must be properly tensioned before using.
4
Chain Drive
Links
Guide-bar Groove
Rotation Direction Arrow
5a
on the Tool Body
Sprocket
Alignment Bulges
Tension-adjusting Pin
5b
Cut Direction
Guide-bar Slot
Chain-tensioning Screw
15