EGO PSA1000 Manual Del Usuario página 34

TROUBLESHOOTING
PROBLEM
Motor does not
run.
Motor runs, but
chain does not
rotate.
34
POLE SAW ATTACHMENT — PSA1000/PSA1000-FC/PSA1020/PSA1020-FC
CAUSE
◾
The battery pack is not
attached to the pole saw.
◾
No electrical contact between
the saw and battery.
◾
The battery pack is depleted.
◾
The lock-off button is not
depressed before pressing
the trigger.
◾
The battery pack or power
head is too hot.
◾
Saw chain is bound in the
wood.
◾
Debris in bar groove.
◾
Debris in chain-sprocket
cover.
◾
Chain does not engage drive
sprocket.
SOLUTION
◾
Attach the battery pack to the pole
saw.
◾
Remove battery, check contacts and
reinstall the battery pack.
◾
Charge the battery pack.
◾
Press down the lock-off lever and
hold it, then depress the trigger to
turn on the pole saw.
◾
Allow the battery pack or power head
to cool until the temperature drops
below 152°F (67°C).
◾
Release the trigger; remove the saw
chain and guide bar from the wood,
then restart the pole saw.
◾
Press the saw chain against the
wood, move the pole saw back and
forth to discharge the debris.
◾
Remove battery pack, then remove
chain-sprocket cover and clean out
debris.
◾
Remove the battery pack and reinstall
the chain, making sure that the drive
links on the chain are fully seated on
the sprocket.