Dupla Perfect Clean PC 1 Instrucciones De Uso página 10

· After cleaning, place the Perfect Clean Filter in the desired location and firmly press the filter in the areas
where the suction cups
· The filter outlet should be located approx. 2 - 3 cm below the water level.
· To remove the filter from the aquarium glass, remove the suction cups suction cups from the aquarium glass,
pulling slightly.
· The distance to the aquarium glass created by the suction cups
resonance.
· In aquaria with a low water level, the Perfect Clean Filter can simply be attached to the aquarium glass
vertically.
Putting the Perfect Clean filter into operation:
· Turn the adjustable, rotatable water outlet
h.
nozzle attachment
· Now connect the Perfect Clean Filter to the mains.
· The nozzle attachment
which is important for plant growth, from the water.
· The flow rate can be adjusted as necessary at the adjustable water outlet.
· To avoid damage to the pump, the flow rate must be at least approx. 100 or 250 l/h (depending on the model).
Replacing a filter: Do replace an existing filter with a new Perfect Clean Filter, we recommend first operating the
Perfect Clean Filter parallel in the same aquarium for 2 weeks before removing the old filter. This ensures optimum
colonisation of the new Perfect Clean filter with cleaning bacteria and prevents dangerous ammonia and nitrite.
Cleaning and maintenance:
Caution: Please read this entire section before each cleaning of the Perfect Clean filter!
Always disconnect all devices in and on the aquarium from the mains for maintenance and repairs! Only then
may the filter be removed from the water.
· If the filter performance has declined significantly or the pH value of the aquarium water declines significantly,
the filter is either clogged or its bacterial activity is too high.
· To ensure optimum water filtration, the filter sponge
e.
· The filter sponge should not be used for more than 6 months and be replaced after this period.
· The filter cartridge
f.
alternatively carefully open the filter cartridge with a slot screwdriver at the designated points and manually
replace the contents or replace it with any filter material.
· Before using new filter media, rinse them once with the aquarium water so the necessary bacterial cultures
can grow.
· To clean or replace the filter sponges
Simply remove the filter insert
· You can now clean the filter media in a bucket with aquarium water or lukewarm tap water, or replace them
with new ones.
· You should only replace part of the filter media at a time to preserve the useful filter bacteria.
· You should also always clean the drive unit with impeller
maintenance.
· To do so, push in the dotted locking mechanism on both sides at the same time and pull off the pump head.
· Carefully remove (e.g.: with tweezers) the impeller
impeller chamber with clean water.
· Now reassemble all parts. Ensure the power cable is in the correct location!
· The total cleaning time of the filter should not exceed 30 minutes to prevent killing residual bacteria in the
filter media.
· We recommend adding Dupla Bacter cleaning bacteria (item no.: 80369) after cleaning the filter to restore the
biodegradation process.
· This is strongly recommended if the filter was out of use for more than 30 minutes.
Please do not use cleaning agents!
10 Dohse Aquaristik GmbH & Co. KG · Otto-Hahn-Str. 9 · 53501 Gelsdorf · Germany
are located.
i.
g.
in the desired direction of flow and, if desired, attach the
to the water outlet .
g.
h.
should not be used on planted aquaria with CO
with the zeo carbon mixture should be changed every 6 weeks at the latest. You can
e.
and the filter cartridge
d. .
i.
prevents noise being transmitted by
supply. This would expel the CO
2
e. should be rinsed after approx. 4 - 6 weeks.
f.
and check them for wear when performing
b.
and clean it with a soft cleaning brush. Also rinse the
b.
,
2