Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING PACKAGING REINFORCEMENT
Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
REMOVING THE TRANSPORTATION LOCKS
WARNING: Do not remove the transportation locks before taking out the packaging
reinforcement.
WARNING: Remove the transportation safety bolts before operating the washing
machine! Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until they rotate freely (C).
2. Remove transportation safety bolts by turning them gently.
3. Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P)
Keep the transportation safety bolts in a safe place to reuse when the washing
machine needs to be moved again in the future.
Never move the product without the transportation safety bolts properly fixed in
place!
CONNECTING WATER SUPPLY
The water supply pressure required to run the product is between 1 to 10 bars (0.1
– 1 MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open
tap in one minute to have your machine run smoothly.
Attach a pressure reducing valve if water pressure is higher.
WARNING: Models with a single water inlet should not be connected to the hot water
tap. In such a case the laundry will get damaged or the product will switch to
protection mode and will not operate.
WARNING: Do not use old or used water inlet hoses on the new product. It may
cause stains on your laundry.
70
Publicidad
