Publicidad
Idiomas disponibles
Idiomas disponibles
1. Put a container below the left drain plug for the
engine oil.
2. Remove the dipstick.
3. Remove the drain plug.
Troubleshooting schedule
If you cannot find a solution to your problems in this
owner's manual, speak to your Zenoah service agent.
Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
297 - 002 - 09.11.2017
Troubleshooting
Cause
The parking brake is not applied. See
page 14 .
The lift lever for the cutting deck is in mow position. See
ting deck on page 12 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
battery on page 18 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
4. Let the oil run out into the container.
5. Attach the drain plug and tighten it.
To do a check of the engine oil level on page 20
6. See
for instructions how to fill oil.
7. Run the engine warm, then make sure that there is
no leakage from the oil plug.
To apply and release the parking brake on
To replace the main fuse on page 18 .
To charge the battery on page 18 .
To fill fuel on page 11 .
To replace the air filter on page 17 .
To lift and lower the cut-
To charge the
21
Publicidad
