Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The engine apparently has no
power
The battery does not charge
There is vibration in the product
The cutting result is unsatisfacto-
ry
Transportation
•
The product is heavy and can cause crush injuries.
Be careful when you load it onto or off a vehicle or
trailer.
•
Use an approved trailer for transportation of the
product.
•
Make sure that you have knowledge of local road
traffic regulations before transportation of the
product in a trailer or on roads.
To safely attach the product on a trailer for
transport
WARNING: The parking brake is not
sufficient to lock the product during
transport. Attach the product tightly to the
trailer.
22
Cause
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle control is set to choke position or the throttle wire is incorrectly ad-
justed
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
charge the battery on page 18 .
The blades are loose. See
One or more of the blades are unbalanced. See
20 .
The engine is loose.
The blades are blunt. See
The grass is long or wet. See
The cutting deck is skew.
There is grass blockage in the cutting deck. See
15 .
The tire pressure is different on the right and left sides. See
page 19 .
The product is operated at a too high speed. See
14 .
The engine speed is too low. See
The drive belt slips.
Transportation, storage and disposal
To replace the air filter on page 17 .
Battery safety on page 8 .
To examine the blades on page 20 .
To examine the blades on page
To examine the blades on page 20 .
To get a good result on page 14 .
To get a good result on page 14 .
Equipment: 2 approved tension belts and 4 wedge
shaped wheel blocks.
1. Apply the parking brake.
2. Attach the tension belts around the frame or rear
wagon.
3. Tighten the tension belts in the direction of the rear
and the front of the trailer to secure the product.
4. Put the wheel blocks in front of and behind the rear
wheels.
To tow the product
The product has a hydrostatic transmission. To prevent
damage to the transmission, tow the product short
distances only and at low speed.
Disengage the transmission when you tow. See
engage and disengage the drive system on page 12 .
To clean the product on page
Tire pressure on
To get a good result on page
297 - 002 - 09.11.2017
To
To
Publicidad
