Quicke Flexibal 200 Manual De Instrucciones página 15

Warning!
Do NOT stand, walk or work under or beside a
raised loader. Make sure you keep everybody,
especially children and animals, away from the
work area.
4.2.1. Dump/Roll back the implement
Right-hand fitting: Move the lever to the left (4) to roll back
the implement.
Move the lever to the right (5) to dump the implement.
Note. With left-hand mounting, the movements will be
reversed. (This does not apply to EasyDrive LCS and
ElectroDrive LCS which only have right-hand mounting.)
4.2.2. Open/close the implement -
EasyDrive LCS and ElectroDrive LCS
To open and close the implement, use the third hydraulic
function which is controlled by switch F2.
When the lever is moved to the right (5) the implement is
opened, and when moved to the left (4) the implement is
closed (right-hand fitting).
When the switch for the third hydraulic service is released
then the control immediately returns to the dump/roll back
function.
4.2.3. Open/close the implement -
ErgoDrive LCS/ErgoDrive
To open and close the implement, use the third hydraulic
function which is controlled with a switch (A) on the front
of the joystick control.
When the lever is moved to the right (5) the implement is
opened, and when moved to the left (4) the implement is
closed (right-hand fitting).
The movements are reversed for left-hand fitting.
When the switch for the third hydraulic service is released
then the control immediately returns to the dump/roll back
function.
Fig.19 Do NOT stand, walk or work under a lifted loader.
4 5
Fig.20 Dump/Roll back the implement
F2
Fig.21 Open/close the implement - EasyDrive LCS and
ElectroDrive LCS
A
5
Fig.22 Open/close the implement - ErgoDrive LCS/ErgoDrive
13
Driving instructions
4
5
0221
5
4 4
4 4
0222
5
0412
5