Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Installation and adjustment
Please install and adjust the machine according to the requirements of the
manual.
It is very important to your safety and correct operation.
Unpacking
You are advised to keep all the packaging for reuse in case the machine is to be
transported again.
Installing the bottom cover
side, put down the machine on some soft thing,
please let the remarkable face outside, the arrow
direction is
machine front side.
bottom cover, use the appendix screw to fasten
the bottom cover.
Positioning
The distance between the washing machine and
the wall should be more than 50mm, and the
maximum allowed angle of the shank base of the
machine is 1°.The slanting or rough ground may
cause operating stopped or unstable, please
adjust it with the following methods:
Make it horizontal
Use a tied thread with plumb to check if it is
horizontal.
Adjust the adjustable foot
Lift up the adjustable foot gently, loose the
adjustable nut and twist the adjustable foot.
Fasten the nut after adjustment.
05
Publicidad
