VOSS.PET fenci duo MD06 Instrucciones De Operación página 34

8 CLEANING
NOTICE
»
Do not use aggressive solvents/cleaning agents, brushes, sharp objects or
similar for cleaning. These can damage the surface.
»
Do not submerge the device in water or other liquids. There is a risk of a short
circuit.
Clean the device with a damp soft cloth if it is dirty.
9 MAINTENANCE
The device requires little maintenance. However, you should carry out regular visual inspections.
Check the device for damage before each use. There are no serviceable parts inside the device.
N OTICE
Do not use the device if there is any visible damage.
10 TROUBLESHOOTING
NOTICE
»
Do not make any unauthorised changes or modifications to the device.
»
Never open the housing. Contact Customer Service for repairs.
If the device malfunctions or is found to be otherwise defective, even after following the suggested
solutions below, contact the manufacturer. The contact details can be found in chapter 19.
Fault/Problem
Device does not
function/ LED
does not light up
LED flashes red
Voltage loss/
leakage on the
fence
Short-circuit of
the fence supply
line
34
Solution
∙
Check the functionality of the device (see section 7.3).
∙
Check the socket used. Contact Customer Service for repairs.
∙
Check the condition of the connected battery. Replace or charge the
battery if necessary.
∙
Rapid double flashing: Battery voltage has dropped below 12 V. Check
the condition of the connected battery. Replace or charge the battery
if necessary.
∙
Rapid short flashing: Battery voltage has dropped below 11.4 V and the
device has switched off. Replace or charge the battery if necessary.
∙
Fence voltage dropped below 2.5 kV. Check the condition of the fence.
∙
Remove vegetation from the fence (mowing, cutting back).
∙
Check whether the insulators are defective (recognisable by "cracking"
and possibly sparking in the insulator). Replace defective and weathered
insulators.
∙
Check whether the conductor material touches the ground (e.g. due
to breaks, insufficient tension). Repair the fencing, use only special
connectors and tension the conductor material.
∙
Check whether the conductor material has unfavourable properties (thin
conductor, high resistance). Use high-quality thicker conductor material
with low resistance. Ensure high quality wiring of the conductor material.
∙
Make sure that the conductor material is not connected by knots and
that there is an adequate connection. Use suitable special conductor
connectors for the conductor material.
Do not use a conventional electrical cable for the supply line. We recommend
using a high-voltage cable (art. 32611).
INSTRUCTION MANUAL VOSS.PET FENCI DUO
41225 - 12.2022 - V1