ZKTeco AL40 Guia De Instalacion página 9

Install the Indoor Assembly
7
Connect the cable to the port on the Indoor Assembly.
1)
2) Position the Indoor Assembly appropriately on the Mounting Plate. Then use Screw C
to fix the Indoor Assembly.
Note: The Knob dot must be positioned in the direction of Bolt.
Physical Testing
8
Rotate the Knob to check if the Deadbolt works properly.
1)
2) Insert the Key and rotate to check if the Deadbolt works properly.
Note: If the Knob or Key cannot control the Deadbolt correctly, please read the Installation
Procedure carefully and re-install the lock.
Warning: Do not install the batteries until the lock is properly installed.
Screw C
7