Publicidad
Idiomas disponibles
Idiomas disponibles
11 Quick-clamping nut
12 Protection guard
13 Grinding/cutting disc*
14 Hand guard*
15 Rubber sanding plate*
16 Sanding sheet*
17 Round nut*
18 Cup brush*
19 Cutting guide with dust extraction protection
guard*
20 Diamond cutting disc*
*Not all of the accessories illustrated or described are
included as standard delivery.
Technical Data
Angle Grinder
Article number
Rated power input
Output power
No-load speed
Grinding disc diameter, max.
Thread of grinder spindle
Weight according to EPTA-Procedure 01/2003
Protection class
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these val-
ues can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
Declaration of Conformity
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 50144 according to
the provisions of the directives 89/336/EEC,
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
1 609 929 J46 • 15.12.05
*
Dr. Eckerhard Strötgen
Head of Product
Certification
Noise/Vibration Information
Measured values determined according to EN 50144.
Typically the A-weighted noise levels of the machine
are: sound pressure level 87 dB(A); sound power level
100 dB(A).
Wear hearing protection!
When using the standard auxiliary handle, the typically
weighted maximum acceleration is 4.5 m/s
When using the vibration-dampening auxiliary handle,
the hand-arm vibration is typically lower than 2.5 m/s
GWS 8-115 Z
PROFESSIONAL
3 601 H31 2..
W
W
rpm
mm
kg
Assembly
Mounting the Protective Devices
Before any work on the machine itself, pull the
mains plug.
Protection Guard
For work with grinding or cutting discs, the pro-
tection guard 12 must be mounted.
English–5
2
.
GWS 10-125 Z
PROFESSIONAL
3 601 H32 2..
800
500
11000
115
M 14
2.1
/II
Place the protection guard 12
onto the spindle collar accord-
ing to the illustration. The trian-
gular
markings
protection guard must corre-
spond with the respective
markings on the spindle collar.
Press the protection guard 12
onto the spindle collar until the
shoulder of the
guard is seated against the
flange of the machine, and turn
the protection guard until it can
clearly be heard to engage.
2
.
1000
630
11000
125
M 14
2.3
/II
on
the
protection
Publicidad
