Bostitch N58C-1-E Manual De Instrucciones página 8

m Warning!
• IMPORTANT SAFETY INFORMATION ENCLOSED.
• READ THIS MANUAL BEFORE OPERATING THE TOOL.
GB
• SAVE FOR FUTURE REFERENCE.
• FAILURE TO OBSERVE THE FOLLOWING
WARNINGS COULD RESULT IN INJURY.
• Do not use damaged, frayed or
deteriorated air hoses and fittings.
• Air powered tools can vibrate in use.
Vibration, repetitive motions or
uncomfortable positions may be harmful
to your hands and arms. Stop using any
machine if discomfort, tingling feeling
or pain occurs. Seek medical advice
before resuming use.
• Do not carry the tool by the hose.
• Keep body stance balanced and firm.
Do not overreach when operating this tool.
• Always turn off the air supply and
disconnect the air supply hose before
installing, removing or adjusting any
accessory on this tool, or before
performing any maintenance on this tool.
• Use protective equipment such as
glasses, gloves, safety shoes as well
as acoustic protection. Remain vigilant,
use common sense and pay attention
when using the machine.
• Always wear suitable CE marked
eye protection when operating or
performing maintenance on this tool.
• Operate at no more than the tool's
maximum pressure stated in column
MAX
"I" of the technical data table.
PSI
• Do not over-oil and do not use heavy
grade oil as stalling and low
performance may result.
8
m This tool is intended to be used for fastening wood
to wood in pallet/crate (-1-E / -2-E / -2-M) and
construction applications (-2-E / -2-M). DO NOT USE for
fastening harder materials which could cause buckling
of the fasteners and damage to the tool. If you are unsure
of the suitability of this tool for certain applications,
please contact your local sales office.
LOADING THE TOOL
m Warning! When loading the tool 1) Never place
a hand or any part of the body in fastener discharge
area of the tool; 2) Never point the tool at self or
anyone else; 3) Do not pull the trigger or depress
the safety yoke as accidental actuation may occur,
possibly causing injury.
Note: Use only fasteners recommended by Bostitch
for use in Bostitch tools or nails which meet Bostitch
specifications.
LOADING (ALL MODELS)
1. Disconnect the tool from the air supply.
2. Open the magazine: Pull down on the latch and
swing the door open. Swing magazine cover open.
(Fig. 1)
3. Check adjustment: the nailer must be set for the
length of nail to be used. Nails will not feed smoothly
if the magazine is not correctly adjusted. To adjust
the magazine, refer to 'Adjusting the Magazine'
shown below.
4. Load the coil of nails: Place the coil of nails over the
post in the magazine. Uncoil enough nails to reach
the feed pawl. Place the first nail in front of the front
tooth on the feed pawl, in the driver channel. The nail
heads must be in the slot in the nose. (Fig. 2)
5. Swing the door/magazine cover closed. Check that
the latch engages when released. (If it does not
engage, check that the nail heads are in the slot in
the nose.)
ADJUSTING THE MAGAZINE
(N80CB-1ML-E, N8090CB-1ML-E ONLY)
1. Release the canister latch on the rear of the canister.
(Fig. 3)
2. Pull out the canister bottom by swinging right to left
until tabs disengage. (Fig. 4)
3. Inside the canister bracket there are settings in
inches and millimeters. The canister is adjusted
correctly when the length of fastener being used
is shown in the window of the canister bottom.
4. Push back the canister bottom and engage the latch