Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
Please read and understand this entire manual prior to assembling the product.
1. Do not allow children to climb or play in or around this product.
2. Use this unit for its intended purpose only. Do not use shelves as step ladder.
3. To avoid damage, assemble the product on a sturdy, level and protective surface.
4. Make sure all bolts/screws are tightly fastened before the unit is used.
5. Check bolts/screws periodically and tighten them if necessary.
6. Unit must be permanently fastened to the wall with provided hardware;
this storage unit is not designed or intended for freestanding use.
WARNING
UNIT IS INTENDED FOR USE ONLY WITH MAXIMUM WEIGHTS INDICATED.
OVERLOADING STORAGE UNIT WITH PRODUCTS HEAVIER THAN MAXIMUM
WEIGHT MAY RESULT IN INJURY. DISTRIBUTE ANY WEIGHT IN UNITS EVENLY.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 50 minutes
Tools Required for Assembly (not included): Rubber Mallet, Phillips screwdriver.
MAXIMUM LOAD: 30 LBS.(13.6KG)
5
ASSEMBLY INSTRUCTIONS
1. Screw cam bolts (BB) all the way into the small
holes located on side panel left (C) and side panel right
(D) as shown figure. Insert the wood dowels (CC) into
the end holes as a guide, attach stretcher (B) to the
side panel left (C) and side panel right (D) by engaging
cam locks (AA).
Hardware Used
AA
Cam lock
BB
Cam bolt
CC
wood dowel
2. Screw cam bolts (BB) all the way into the small holes
located on top panel (A). Insert the wood dowels (CC)
into the holes pre-drilled on top edge of assembled frame.
Position the top panel (A) onto the inserted dowels and
attach in place by engaging cam locks (AA) as shown
figure.
Hardware Used
AA
Cam lock
BB
Cam bolt
CC
wood dowel
3. Insert the wood dowels (CC) into the holes pre-drilled
on bottom edge of assembled frame. Position the bottom
panel (F) onto the inserted dowels and attach in place by
engaging M4 x 50 mm screws (DD) as shown figure.
Hardware Used
CC
Wood dowel
M4 x 50 mm
DD
Screw
1
AA
B
x 2
C
x 2
D
x 2
2
BB
CC
A
x 6
C
x 6
D
x 6
B
3
C
D
CC
x 4
x 4
6
CC
BB
AA
F
DD
Publicidad
