Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. Expand the back panel (G) and lay it onto the back
edges of assembled frame making sure the margins
along all edges are equal. Attach the back panel in
place by using M3.5 x 15 mm screws (FF) through the
pre-drilled holes of back panel.
Hardware Used
FF
M3.5 x 15 mm Screw
If you plan to use this unit as hutch (stand this on another
one), please skip step 5 & 6.
5. Insert floor levelers (GG) into the bottom of bottom
panel (F).
Hardware Used
GG
Floor Leveler
6. Insert the caps (HH) into the holes on top of the top
panel (A).
Hardware Used
HH
Cap
4
G
x 20
5
x 4
GG
6
x 4
HH
7
ASSEMBLY INSTRUCTIONS
7. Insert the wire stopper (H) into the holes of the shoe
shelf (E).
FF
The shelf can be used as regular shelf by removing the
wire stopper.
8. Set the rear shelf pin (KK) to one hole higher than the
front shelf pin. Tilt and install adjustable shelves (E) in
place. Plug the plastic covers (II) onto the visible cams
locks to conceal the cams.
Hardware Used
II
Plastic cover
F
KK
Shelf pin
9. This cabinet was designed with a feature that allows
stacking two units. Additional units sold separately. Insert
wood dowels (CC) into the holes on top of the base unit.
Place bottom of second unit onto the inserted dowels.
Secure units together by attaching the metal plates (EE)
at both ends with the M3.5 x 19 mm screws (LL) into the
predrilled holes.
NOTE: Remove caps (HH) before stacking two units
together.
A
Hardware Used
CC
Wood dowel
EE
Metal plate
LL
M3.5 x 19 mm Screw
7
E
x 4
8
E
II
E
x 4
E
x 16
E
9
CC
x 4
x 1
x 4
8
H
KK
LL
EE
Publicidad
