Descargar Imprimir esta página

Craftsman BOLT ON 26993 Manual Del Operador página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

to maintain control of the tool at start up, during use, and until the wheel stops rotating. Make sure the
wheel has come to a complete stop before laying the tool down.
cautiOn:
Allow the tool to reach full speed before touching tool to the work
surface. Lift the tool from the work surface before turning the tool off.
USINg CUTTINg WHEEL
WARNING
:
wheels are not designed for side pressures encountered with surface grinding. Wheel breakage
and injury may result.
1. Allow tool to reach full speed before touching tool to work surface.
2. Apply minimum pressure to work surface, allowing tool to operate at high speed. Cutting rate is
greatest when the tool operates at high speed.
3. Once a cut is begun and a notch is established in the workpiece, do not change the angle of
the cut. Changing the angle will cause the wheel to bend and may cause wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow the tool to stop rotating before
setting it down.
mAINTENANCE
CLEANINg
Blowing dust and grit out of the motor housing using compressed air is a necessary
maintenance procedure. Dust and grit from metal grinding often accumulate on interior surfaces
and could create an electrical shock hazard if not cleaned out.
• Always handle accessories with care when mounting or removing.
• The best storage place for accessories is one that is cool and dry away from direct
sunlight and excess heat or cold.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
LUbRICATION
Craftsman
tools are properly lubricated at the factory and are ready for use. Tools should
®
be lubricated regularly every year depending on usage. (Tools used on heavy duty jobs and
tools exposed to heat may require more frequent lubrication.) This lubrication should only be
performed by a qualified power tool repair person.
ACCESSORIES
Warning:
The use of any accessory not recommended for use with this tool could be
hazardous.
• Replacement Craftsman
outlets. You may also use standard 3" diameter, 1/16" thick cutting wheels that fit the 3/8" arbor
diameter (hole in the center of the wheel) available at most hardware stores.
problem
• Attachment will not start.
nOte: Refer to Power Unit instruction manual for troubleshooting solutions regarding operation of the
Power Unit.
Do not use cutting wheels for surface grinding applications because these
cutting wheels, item 18834, are available at most Craftsman
®
trOubleShOOting
possible cause
• Attachment is not secured.
possible Solution
• Make certain the attachment is fully pushed into
the Power Unit.
8
®

Publicidad

loading