Descargar Imprimir esta página

Hitachi CC 14SF S Instrucciones De Seguridad Y Manual De Instrucciones página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE USING
1. Make sure the power source is appropriate for the tool.
WARNING:
2. Make sure the trigger switch is turned OFF.
WARNING:
3. Check the cut-off wheel for visible defects.
Confirm that the cut-off wheel is free of cracks or other visible damages.
4. Confirm that the cut-off wheel is fixed securely to the power tool.
Using the supplied hex. bar wrench, tighten the clamping bolt on the cut-off wheel
mounting shaft to secure the cut-off wheel.
WARNING:
5. Check the sub cover (A) for proper operation.
Possible accidents such as a cracked out-off wheel is prevented by this sub cover (A)
(wheel cover).
Although it has been fully clamped at the factory prior to delivery, securely reclamp the
mounting screws for safety.
Sub cover (A) and wheel cover are designed to protect the operator from coming into
contact with the cut off wheel during operation of the tool.
WARNING:
6. Use cut-off wheels whose peripheral speed ratings are over the maximum
working peripheral speed.
When replacing the cut-off wheel, ensure that the replacement cut-off wheel has a
designed peripheral speed in excess of 16,000 ft/min (4,800m/min).
WARNING:
7. Confirm the stopper position.
Confirm that the stopper which was used for installtion and removal of the cut-off
wheel has returned to the retract position.
8. Securely fix the cutting material.
Ensure that the material is securely fastened with the vise. If it is not, a serious accident
could be caused if the material comes loose or the cut-off wheel breaks during operation.
Never connect the power tool unless the available AC power source
is of the same voltage as that specified on the nameplate of the
tool.
If the power cord is connected to the power source with the trigger
switch turned ON, the power tool will start suddenly and could
cause a serious accident.
When the clamping bolt is loose, the cut-off wheel may be damaged
when the wheel axle starts revolving, causing a hazardous
condition.
NEVER OPERATE THE POWER TOOL if the safety covers do not
function smoothly.
Never use cut-off wheels whose peripheral speed ratings are under
the maximum working peripheral speed.
English
11

Publicidad

loading

Este manual también es adecuado para:

Cc 14sf