Publicidad
Idiomas disponibles
Idiomas disponibles
2. Switch operation.
Hole
Fig. 6
WARNING:
3. Cutting operation.
(1) Rotate the cut-off wheel, gently press down the handle, and bring the cut-off wheel
close to the material to be cut.
(2) When the cut-off wheel contacts the material, gently press down the handle further
and start cutting.
(3) When cutting (or designated slotting) is completed, raise the handle and restore it
to its original position.
(4) At the termination of each cutting process, turn OFF the switch to stop rotation and
proceed with the subsequent cutting job.
WARNING:
CAUTION:
●
Increased pressure on the handle will not increase the cutting speed.
On the contrary, too much pressure may result in overload of the motor and/or
decreased cutting efficiency.
Pull the trigger to turn on the switch, release it to shut
it off.
Trigger
After releasing the trigger, make sure the trigger has
Switch
gone all the way back and the switch is turned off
This will ensure that the power tool cannot be turned on accidentally
or by someone (especially a child) who is not qualified to use the power
tool.
To prevent unauthorized operation of this tool, insert a padlock through
the hole in the switch trigger
Confirm that the trigger switch is turned OFF and that the power plug
has been removed from the receptacle, whenever the tool is not in
use.
Always remove the lock-off button from the handle, and store it in a
secure place, after completing the work.
.
English
.
13
Publicidad
