Diesel Engine Hatz 1B20 - ENAR CRENA 22 Manual De Instrucciones

5.2 DIESEL ENGINE HATZ 1B20

1. Set throttle to "idle".
2. Starter cord slowly pull the handle stops and slowly release it back when you move it while holding hands.
Then pull the starter cord handle until you feel resistance, then grip the handle firmly with both hands and pull
sharply. The engine starts.
Starter cord handle drop sharply back. In retrospect, moving her hands to hold. (The procedure is graphically
illustrated starting the engine HATZ).
If the machine is equipped electric start turn the key in the ignition (1), as shown, after the engine starts
release the ignition key. You can also start it manually (eg low battery). It is always necessary to turn the
ignition key to start position, otherwise you can not start the engine.
en
3. Leave the motor full load while running at idle speed, to keep warm.
4. Move throttle lever (1) to "full throttle". At about 1700 RPM centrifugal clutch automatically switches and
the machine begins to vibrate.
5. Reverse lever is tilted forward and automatically starts the machine forward.
REVERSIBLE VIBRATORY PLATE COMPACTOR
CRENA 22*, 26*, 32*
22