Publicidad
Idiomas disponibles
Idiomas disponibles
User manual
5. - HOW TO USE THE PRODUCT WITH PROGRAMMER PCT 4.0
5.1.- MAIN MENU
When the programmer connector is inserted
in the "PRGM" socket of the QPSK-PAL
front pannel the first information displayed is
the programmer version.
Then the unit version and build number are
displayed:
a.- Output menu
The first main menu shows the output fre-
quency/channel (depending on the freq.
mode) and the output level.
The output frequency range is 47-862 MHz.
The output level control ranges from 00 to
99.
To change the frequency you must press
the
button until is located over the selec-
ted digit. By using
and
modify the value of the digit . The following
decimal values are permitted for the output
frequency:
=> .00 MHz
=> .25 MHz
=> .50 MHz
=> .75 MHz
To modify the output channel and the output
level you must press
until the cursor is
situated over the desired parameter, the
value can be modified by pressing
.
36
To switch between frequency mode and
channel mode see 5.2. EXTENDED MENU.
b.- Input menu
The folowing menu enables the choice of
input frequency (950-2150 MHz), input band
you can
rate QPSK (3-45 Mbaud) and the selecting
of converter feed LNB (0V, 13V, 17V and
tone 22KHz).
To modify a parameter you must press
until the desired parameter flashes on and
off. Then you can change the value using
and
and
QPSK-PAL
Publicidad
