Publicidad
Idiomas disponibles
Idiomas disponibles
User manual
To carry out a modification the
be pressed until the desired parameter flas-
hes. Then the parameter can be modified
just pressing the
and
keys.
e.- Configuration menu
Through this menu the address of the unit
can be selected (so that it can be controlled
by the Headend Controller CDC). To be able
to control a headend remotely each device
should have a different address (1 to 254).
From this menu you can switch between fre-
quency and channel table mode.
The following channel tables are available:
Table 1: CCIR, New Zealand and Indonesia.
Italian channels.
Table 2: China, Taiwan and CCIR hyper-
band.
Table 3: M/N, Chile.
key must
Table 4: France.
Table 5: Australia.
Table 6: Southafrica, K1 (8 MHz), I (Ireland,
8MHz).
Table 7: Former URSS and OIRT.
Table 8: New CCIR table with all the chan-
nels
To carry out a modification the
be pressed until the desired parameter flas-
hes. Then the correspondent parameter can
be modified by pressing
f. Scan transponder menu
This menu allows the user to repeat the
exploration of the input signal, for example,
if the names of the services haven't been
found. To force a new exploration just press
or
.
This menu only appears when the unit is
hooked.
g.- Language selection menu
The last extended menu allows the selection
of
(English/Spanish/German).
key must
and
.
By pressing
different languages.
Note: It is necessary for the unit to be loc-
41
QPSK-PAL
the
menus
language
or
you switch between
ked onto QPSK so that the following
menus can be selected:
- Audio menu
- Audio for language/index (audio
mode)
- Video format (letterbox, fullscreen...)
- Subtitles menu
Publicidad
