Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING YOUR WINE CELLAR
Unpacking Your Wine Cellar
1. Remove all packaging material. This includes the base and all adhesive tape
holding the wine cellar accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before
powering on the wine cellar.
Proper Air Circulation
• To assure your wine cellar works at the maximum efficiency it was designed
for, you should install it in a location where there is proper air circulation and
electrical connections.
• The following are recommended clearances around the wine cellar
Sides ..................... 2" (50mm)
Top ....................... 4" (100mm)
Back ...................... 2" (50mm)
• Do not over fill your wine cellar for proper internal air circulation.
NOTE: Allow enough space in the front of the unit toopen the door
to 120˚.
Grounding Instructions
• Make sure there is a suitable power outlet (115V~60Hz 15A) with proper
grounding to power the wine cellar.
• Avoid the use of three plug adapters or cutting off the third grounding pin
in order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the wine cellar and may result
in shock ha
zard.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under
certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
English
4
Publicidad
