Quicke Flexigrip 160 Manual Del Operador página 14

Driving instructions
4. DRIVING INSTRUCTIONS
4.0.1. Designated use
The attachment is equipped with two grip arms that are
used to carry the material. Transport the material as low as
possible. The main application area is the handling of:
Lower the loader as far as possible when moving. Keep
in mind that the higher you lift the loader, the higher the
centre of gravity, resulting in increased risk of the tractor
overturning.
4.0.2. Fitting
The attachment is supplied partly fitted.
The cylinder is supplied in the accompanying accessories
box. Attachments and hoses between the implement and
operating machine are supplied in separate kits. The
cylinder (1) is fitted with the oil connections backwards.
The pins (2) are locked with screws (3) as shown. The
cylinder bearings are lubricated prior to fitting the pins.
The right or left grip arm movement can be limited using
the strut (1). The strut is fitted between the frame and the
pin. With the strut fitted, the bales can be stacked closer
together. When handling bales of 120cm diameter, two
further holes in the strut should be used (applicable to
Flexigrip 160).
Back Stop
Som en extra säkerhetsåtgärd kan man montera en s.k.
Back Stop. Denna hindrar balar från att rulla bakåt över
traktorföraren. Den finns att beställa som tillbehör.
Fig.18 Fitting the hose kit.
2
3
1
3
Fig.19 Fitting the cylinder and the restriction brace.
Fig.20 Fitting the BackStop
12
2
4
1
3
2