Quicke Flexigrip 160 Manual Del Operador página 18

Driving instructions
4.1.6. Operating instructions
To avoid damage to the plastic, the upper section of the grip
arm should be placed at the same level as the upper edge
of the bale. Transport the bale horizontally - crowd it to
vertical once at the loading/storage location.
Note. The bale should be turned at the lowest possible
height as. For longer transportation distances, the grip can
reduce, due to inner oil leakage in the loader's control valve,
so that in the worst case scenario, the bale can be dropped.
If this could be an issue, the implement can be equipped
with a load holding valve (extra equipment).
Warning!
For longer transportation distances, the grip can
reduce, due to inner oil leakage in the loader's
control valve, so that in the worst case scenario,
the bale can be dropped.
To prevent "lost bales" caused by inner oil leakage, you can
stop and increase the grip on the bale at regular intervals or
the implement can be fitted with a load holding valve (extra
equipment).
4.1.7. Parking the implement
Do not disconnect the cylinder from the implement at any
of the end positions - difficulties may arise due to over-
pressure, when the quick connections are to be connected.
See also the chapter "Connection and disconnection of the
implement" in the loader operating manual.
Fig.29 Transport the bale horizontally and at a low height (1) -
crowd it to vertical once at the loading/storage location (2).
16