Koblenz Acquapur II Manual De Uso página 4

VACUUM ASSEMBLE
CAUTION:
WATER FILTER USE
1
1. Open reservoir cover. Fig. 1
2. Remove transparent reservoir by holding it from handle and put it a side. Fig. 2
3. Pull out water filter body. Fig. 3
4. Compare parts and accessories in the instruction manual with those on the package.Check
if any of them is missing or damaged.
5. If you are going to use your vacuum cleaner, put water inside transparent water tank until
maximun level specified (Max. 1.2 lt.). Do not put water into below or above this level.
6. To ensure a pleasant scent on room, and that dirty water doesn´t produce foam, drip 2-3
drops of given defoamer with vacuum cleaner into water.
7. Slot water filter body onto it's place on water tank. Fig. 4
8. Make sure air inlet grill is inserted into water filter body. Insert it, if it is not. Close the reservoir
cover. Fig. 5
9. Insert motor protection's filter into it's slot on the main body. If the motor protection's filter is
not inserted, vacuum cleaner cannot make sufficient suction.
Please make sure motor protection's filter is inserted into its slot.
10. Insert transparent reservoir set into the main body tightly.
11. In order to connect hose to the main body, press locking buttons on vacuum head of hose
and place it in the vacuum head on tank. Fig. 6
4
4
Unplug power cord before performing any maintenance on it.
2
5
Never make water suction with it on wet floor.
Only make dry sweeping with your vacuum cleaner.
CAUTION:
3
6