Koblenz Acquapur II Manual De Uso página 6

POWER CONTROL
12
PULL OUT LINE CORD
14
WATER TANK LEVEL
Fill the tank with water up to the MAX level.
NOTE: Before and after each use, tank must be cleaned for better
performance of your vacuum cleaner. Fig.15
CLEANING AND MAINTENANCE
CAUTION:
Prior to cleaning always disconnect appliance from electrical supply. The vacuum cleaner, specially
water tank and all accessories, can be cleaned using a damp cloth or a non abrasive domestic
cleaner and then should be wiped dry. To keep underside of the appliance clean, vacuum it at
regular intervals.
WATER TANK
Always drain water inside transparent water
tank. After each use; clean and dry the tank.
Fig.16-17
To prolong your vacuum cleaner´s life and
due to hygienical reasons, do not leave your
vacuum cleaner full of liquid and dirt.
Pull off the water filter body. The water filter
body can be washed in warm or soapy
water or in flowing water (under the tap).
After washing, dry it first, then insert it.
FILTER
Cleaning of motor protections filter placed under the transparent water tank on the main body
must be checked periodically and must be cleaned with warm water, if necessary. Before using
it again, make sure the filter is dry. It must be cleaned every month at least depending on the
frequency of usage.
6
13
1. LINE CORD
Pull out line cord and plug until yellow mark. Fig. 14.
Press the ON/OFF switch to start motor.
2. CORD REWIND
After sweeping process is completed, turn it off by pressing on to
On-Off button.
Unplug vacuum from outlet, then press rewind button with one hand
and guide cable with the other hand to ensure that it does not whip
causing damage. Fig.14
Note: Never exceed the red mark.
Unplug power cord before performing any maintenance on it.
16
This vacuum cleaner has a rotary knob for
suction control. Turn knob according to suction
power needed. Fig.12
You may increase or decrease suction power
of your vacuum cleaner by turning suction
power control knob to the right or to the left.
Fig.13
17
15