Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove the battery pack
WARNING
any time the tool is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Only use MILWAUKEE-designed sockets and
anvil adapters. Other sockets and anvil adapters
could shatter or break, causing injury.
Attaching/Removing Sockets
and Adapters
WARNING! Remove battery to avoid starting the tool.
• To insert the adapter into the ratchet,
line up the adapter with the spline
opening on the ratchet, and push
firmly until they click together. Insert
from the bottom or top of the tool,
as shown. Ensure the adapter is
secured in place before use. Some
MILWAUKEE sockets can be used
without an anvil adapter.
• To attach a socket or accessory,
press it firmly into place on the
adapter.
• To remove the socket or accessory, pull firmly away
from the tool.
• To remove the adapter, pull the adapter out of the
ratchet spline.
NOTE: Choose the correct accessory for the job.
OPERATION
To reduce the risk of injury, always
WARNING
wear proper eye protection marked
to comply with ANSI Z87.1.
When working in dusty situations, wear appro-
priate respiratory protection or use an OSHA
compliant dust extraction solution.
Fuel Gauge
To determine the amount of charge left in the battery,
turn the tool ON. The Fuel Gauge will light up for 2-3
seconds. When less than 10% of charge is left, 1 light
on the fuel gauge will flash 4 times.
To signal the end of charge, 1 light on the fuel gauge
will flash 8 times and the tool will not run. Charge
the battery pack.
If the battery becomes too hot, the fuel gauge lights
will flash and the tool will not run. Allow the battery
to cool down.
Using the Forward/Reverse Toggle
For forward (clockwise) rotation,
rotate the forward/reverse toggle
counterclockwise. Check the direc-
tion of rotation before use.
For reverse (counterclockwise)
rotation, rotate the forward/reverse
toggle clockwise. Check the direction
of rotation before use.
Lock Switch
To lock the paddle switch, slide the lock switch to
the locked
position. To unlock the paddle switch,
slide the lock switch to the unlocked
paddle switch will not work when the lock switch is
in the locked position.
Always lock the paddle switch or remove the battery
pack any time the tool is not in use.
Starting, Stopping and Controlling Speed
1. To start the tool, grasp the handle(s) firmly and
pull the trigger.
NOTE: An LED is turned on when the trigger is
pulled and will go off shortly after the trigger is
released.
2. To vary the speed, increase or decrease the pres-
sure on the trigger. The further the trigger is pulled,
the greater the speed.
3. To stop the tool, release the trigger. Ensure the
tool has come to a complete stop before laying
the tool down.
4
Forward
Reverse
position. The
Publicidad
