Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The doubling or tripling function is only available for
programmed meal preparation modes.
3.3.18 Filter service reminder function
When the filter service reminder function is active (see the table of
device settings), the device will automatically remind the user to
clean the filter - provided it is connected to the power supply.
• When the time to clean the filter has come according to the set
interval, the message "CLEAN FILTER" will appear on the display
- opening the door of the heating chamber at this moment will
turn the device to standby mode.
• (After cleaning the filter) The reminder alarm is reset by pressing
and holding the STOP button for 3 seconds.
3.3.19 Multi-stage preparation
The multi-stage preparation can be adjusted to automatic or manual
food preparation. In total, a 3-stage cycle can be programmed.
• After setting the power level and time for the first stage, press
the TIME ENTRY button and use the number buttons to set the
time.
• After setting the meal preparation time, press the manual
POWER LEVEL button and use the number buttons to select the
power level for the second stage of preparation.
• The setting of the third stage is the same as that in the second
stage.
• Finally, by pressing the START button, start the meal preparation
cycle.
For example: if you want to set the manual preparation mode of a
2-stage meal preparation cycle, where the power for the first stage
is 70% and the preparation time is 1 minute and 25 seconds, and for
the second stage respectively 50% and 5 minutes and 40 seconds,
you must:
a)
Open the cooking chamber door, press and hold down the
number button "1" for 5 seconds until the display shows
"PROGRAM".
b)
Press the number button "3", the display will show "P: 03" and
after 2 seconds ": 30".
c)
Press the number buttons "1" - "2" - "5" in sequence to enter
the preparation time of 1 minute and 25 seconds - the display
will read "1:25".
d)
Press the manual POWER LEVEL button and then the number
button "7" (70% power). The first step of setting the cycle is
complete.
Publicidad
