Publicidad
Idiomas disponibles
Idiomas disponibles
e)
f)
g)
h)
3.3.20 Factory reset of the device
3.4.
Cleaning and maintenance
a)
The unit should be cleaned after each working day or a heated meal if it has
been spilled, splashed, etc. from the cookware.
b)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
Wait until the rotating parts stop.
•
c)
Only mild detergents designed for cleaning food contact surfaces may be used
to clean the unit.
d)
After each cleaning, all the parts should be dried well before the unit is used
again.
e)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
f)
Do not spray the unit with a stream of water or immerse it in water.
g)
Make sure that no water enters through the ventilation openings in the casing.
h)
Clean the ventilation openings with a brush and compressed air.
i)
Perform regular inspections of the unit checking technical fitness and any
damages.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
l)
To facilitate the cleaning of the walls of the heating chamber, you can use the
following solution: place half a lemon in a bowl and pour 300 ml of water. Heat
Press the manual TIME ENTRY button and the display will show
"STAGE-2".
Press the number buttons "5" - "4" - "0" in sequence to enter
the preparation time of 5 minutes and 40 seconds - the display
will read "5:40".
Press the manual power setting button and then the numeric
key "5" (50% power). The second stage of the cycle is
complete.
The START button is used to start the pre-set multi-stage meal
preparation cycle.
In standby mode, press the START + "0" buttons
•
simultaneously and the display will show "CHECK".
•
If the unit is factory-set, the display will show "11". If the
factory settings are modified, the display will show "00".
•
To restore the factory settings, press the START button and
the display should read "CLEAR".
Publicidad
