Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly Instructions
ASSEMBLY OF BUBBLE | PURE AIR
Before assembly, clean the area where the Bubble will be installed and avoid the
presence of sharp objects that could damage the Bubble. Arch system:
1. Locate a power supply for
connection to the Airbox.
4. Close the zip of the Bubble.
Connect the Air+ 600i_BB to
the power supply and turn it
on.
7. Insert the 4 upper rod
sections of the Bubble into
the cross piece. Set the cross
piece parallel to the longest
side of the base. Connect the
rest of the rod sections (3 rods
per side) while the Bubble fills
with air.
DISASSEMBLING THE BUBBLE PURE AIR
After use, switch the Air+ 600i_BB regulator to off and disconnect from the power
supply. Open the zips for better air expulsion.
Always store in its bag when not in use. To disassemble, remove the structure
from the base and disassemble the rods, the cylindrical base structure and carefully
fold the bubble. Store the fabric in its carry case, and the rods, cross piece and
cylindrical base in the other carry bag.
2. Connect the end of the tube
to the outlet on the Airbox
and adjust.
5. Wait about 10 seconds
until the display performs the
function test. When it remains
in WAIT, press the button
"ON". It takes about 6 seconds
to start the engine.
8. Insert the end of the rods to
the anchor points located at
the corners of the floor.
3. Open the velcro from the
base and insert the cylindrical
structure made of 8 rods. Close
the velcro.
6. Then press and hold the
upload button speed "
" a
few seconds until it reaches
the value 50 and check its
operation for a few seconds.
9. After having checked its operation,
it is advisable to set the regulator
to its maximum speed (Hi) for the
first 5 minutes to execute a deep
cleaning of the space. Then, it is then
recommended to leave it at medium
speed, below 50, to maintain optimal
recirculation and comfort speed.
23
Bubble | Pure Air
Publicidad
