enphase EVSE Manual Del Usuario página 15

Mobile EV Charger EVSE User Manual
Figure 3: Mounting Screw Slots of Mobile EV Charger
0.25" (6.3 mm)
Ǿ 0.42" (10.7 mm)
The screw size and length recommended for mounting the EVSE is
#10 and at least 2" (50 mm) long to utilize the mounting tabs for
a travel friendly EVSE. Alternatively, a screw size of 1/4 - 20 and at
least 2" (50 mm) in length can be used for permanent mounting of
the EVSE.
It is important to note that if the mounting tabs are intended to be
used for temporary mounting, the diameter of the screw shaft must
be larger than 0.25" (6.3 mm) and smaller than 0.42" (10.7mm) to
fit into the slot of the enclosure. Screw heads of 0.40" diameter is
recommended.
Page 15