GYS Toparc Kit NUM-2 Manual Del Usuario página 4

WARNINGS - SAFETY RULES
GENERAL INSTRUCTION
These instructions must be read and understood before any operation.
Any modification or maintenance not indicated in the manual must not be undertaken.
The manufacturer shall not be held liable for any personal injury or material damage caused by use not in accordance with the instructions in this
manual. In the event of a problem or uncertainty, consult a qualified person to handle the installation correctly.
This manual describes the wiring of this product. Any user who does not strictly comply with the safety instructions described in this manual may
be exposed to electrical risks and/or a serious or even fatal accident.
ELECTRIC SAFETY
During any intervention on the product, make sure to secure the area by keeping at a distance any person who has not read the instructions of safety
described in this manual. This product should preferably be installed by a professional in accordance with the installation rules in force in the country.
If not, it is recommended that you read these rules before working on it.
PRECAUTIONS AGAINST ELECTROSTATIC DAMAGE
Static electricity can damage electronic equipment. Use a grounded anti-static wrist strap, an ankle strap, or equivalent safety device
to prevent electrostatic damage (ESD) when installing this product.
Electrostatic damage can irreparably damage the generator and/or the product. To protect electronic components from electrostatic damage, place
this product on an antistatic surface, such as an antistatic discharge mat, antistatic bag, or disposable antistatic mat.
KIT CONTENTS
Wire harness
Connector
PRESENTATION
The digital kit NUM-2 (ref. 064942) allows an additional application on compatible MIG/MAG generators. It allows to add a wire feeder for a double
wire feeder configuration.
Compatibility
NEOPULSE 400 G
PULSEMIG 400 G
NEOPULSE 500 G
PULSEMIG 500 G
4
RJ45 Cable
300 mm 750 mm
Double wire feeder
ref.
NEOFEED-4W
ref. 014527
014497
-
062665
014503
-
062672
KIT NUM-2
Case connector
Support plate
cover
PULSFEED-4W
ref. 062689
-
-
Dinse connection
Copper bar
orifice
EN
Cap