Hunter Engineering Company AutoComp Elite OCL400 Serie Instrucciones Funcionamiento página 8

ACE Lathes Installed Outside N. America
The ACE lathe is configured at the factory to operate at 230 VAC, 1 Ph, 50/60
Hz, but can be reconfigured in the field to operate at 115 VAC. This should be
performed by an authorized service representative.
Unit does not ship with a power cable connector. Power cable connector must
be supplied locally.
ACE Series Specifications ACE Series Specifications
Maximum Rotor Turning Diameter
Maximum Rotor Thickness
Maximum Rotor Friction Surface
Area
Feed Distance
Spindle Revolutions
Motor Power
Dimensions
Net Weight
Lubrication
Electric Power
End User License Agreement End User License Agreement
Use of equipment and it's operating software is acknowledgment of
agreement to the terms of the End User Licensing Agreement ("EULA"). The
entire EULA can be found by scanning the QR Code below.
Environmental Information Environmental Information
The following disposal procedure shall be exclusively applied to the machines
having the crossed-out bin symbol on their data plate. Waste Electrical and
Electronic Equipment (WEEE).
This product may contain substances that can be hazardous to the
environment and to human health if it is not disposed of properly.
The following information is therefore provided to prevent the release of these
substances and to improve the use of natural resources.
Electrical and electronic equipment should never be disposed of in the usual
municipal waste but must be separately collected for their proper treatment.
The crossed-out bin symbol, placed on the product and on this page, reminds
the user that the product must be disposed of properly at the end of its life.
In this way it is possible to prevent that a non specific treatment of the
substances contained in these products, or their improper use, or improper
use of their parts may be hazardous to the environment or to human health.
Furthermore, this helps to recover, recycle and reuse many of the materials
contained in these products.
Electrical and electronic manufacturers and distributors set up proper
collection and treatment systems for these products for this purpose.
At the end of the product's working life, contact your supplier for information
about disposal procedures. When you purchase this product, your supplier will
8
400 mm (15.75 inches)
69 mm (2.75 inches)
76 mm (3.00 inches)
110 mm (4.3 inches)
Variable Speed 0-150 RPM forward
and reverse
1.5 HP (1.12 kw) @ 3450 rpm
686 mm Long x 508 mm Wide x 381
mm High (27 inches x 20 inches x 15
inches)
Approximately 41 kg (90 lbs.)
(Without trolley)
Gear box, AGMA #8 Gear Lubricant
Carriage slides, light motor oil
Carriage screw, EP grease
North America
115 VAC, 60 Hz, 15 Amp, NEMA
L5-15P
(230 V, 50-60 Hz optional)
Outside N. America
230V, 1 Ph, 50-60Hz, 17 A
(115V, 1 Ph, 50/60Hz, 15 A, optional)
also inform you that you may return another worn-out appliance to him free of
charge, provided it is of the same type and has provided the same functions
as the product just purchased.
Any disposal of the product performed in a different way from that described
above will be liable to the penalties provided for by the national regulations in
force in the country where the product is disposed of.
Further measures for environmental protection are recommended: recycling
of the internal and external packaging of the product and proper disposal of
used batteries (only if contained in the product).
Your help is crucial in reducing the amount of natural resources used for
manufacturing electrical and electronic equipment, minimise the use of
landfills for product disposal and improve the quality of life, preventing
potentially hazardous substances from being released in the environment
English