Magnusson 5063022087256 Manual Del Usuario página 42

Unit setting
The default unit of measurement is "m" (metres). Five different units
of measurement are available. Press
following units:
0.000m
0.0cm
0 in 1/16"
0'00" in 1/16
0.00ft
Notes: In tape measure mode, measurement data can only be displayed
in units of 0cm and 0'00".
Measuring Single Distance
1. Point the tool's laser toward the wall or object to be measured.
2. Short press
single measurement mode
3. Press
4. To measure, briefly press the measuring button
value will be shown at the bottom of the display.
Repeat steps 3, 4 for each subsequent measurement. The last measured
value is at the bottom of the display, the penultimate measured value is
above it, and so on.
63022087256_MNL_IN_V02.indd 42 63022087256_MNL_IN_V02.indd 42
to turn the tool on, by default the product turns on in
again to switch on the laser beam.
button to switch between the
.
42
.The measured
19/05/2023 4:32:03 pm 19/05/2023 4:32:03 pm