Magnusson 5063022087256 Manual Del Usuario página 44

Measuring Continuously
To take a series of measurements as you move around, change to
Continuous Measure Mode.
1. Point the tool's laser toward the wall or object to be measured.
2. Briefly press the measuring button
3. Press and hold
measurement mode
enlarged format for better legibility.
4. Move the measuring tool until the required distance is shown at
the display. Briefly pressing the measuring button will interrupt the
continuous measurement. The current measured value will be shown
at the display.
Measuring Area
You can measure the area of a wall, floor, or object.
1. Point the tool's laser toward the wall or object to be measured.
2. Briefly Press the measuring button
3. Press the menu button
mode
4. Then measure the width and length one after the other as with a length
measurement.
5. The first measured value is shown at the top of the display. After
the second measurement has been completed, the area will be
automatically calculated and displayed. The end result is shown at the
bottom of the display, while the individual measured values are shown
above.
63022087256_MNL_IN_V02.indd 44 63022087256_MNL_IN_V02.indd 44
for approximately 2 seconds to enter continuous
,the measured value is displayed in an
.
to turn the tool on.
to turn the tool on.
once to select the area measurement
44
19/05/2023 4:32:04 pm 19/05/2023 4:32:04 pm