Depth Adjustment; Safety Switch - Bosch 1659 Instrucciones De Funcionamiento Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BM 2610925945 6-05
Disconnect battery pack from tool. Loosen the
depth adjustment knob located on the back
side of the upper guard. Hold the foot down
with one hand and raise or lower saw by the
handle. Tighten knob at the depth setting
FIG. 3
CALIBRATED DEPTH
BRACKET

SAFETY SWITCH

The safety switch is designed to prevent
accidental starts. To operate safety switch,
press the release button with your thumb on
either side of handle to disengage the lock,
then pull the trigger (Fig. 5). When the trigger
is released the button will engage the safety
switch automatically, and the trigger will no
longer operate. (See Switch & General Cuts
on page 11.)
FIG. 5
SAFETY SWITCH
6/10/05
10:30 AM
Operating Instructions

DEPTH ADJUSTMENT

DEPTH
ADJUSTMENT
KNOB
BLADE
WRENCH &
STORAGE AREA
RELEASE
BUTTON
TRIGGER
Page 11
desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
FIG. 4
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
90° CUTTING ANGLE CHECK
Disconnect battery pack from tool. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment knob, set to 0° on quadrant,
retighten knob and check for 90° angle
between the blade and bottom plane of foot
with a square (Fig. 6). If adjustment is
necessary, tilt foot to 45°, tighten bevel
adjustment wing nut and bend "TAB" with an
adjustable wrench or pliers (Fig. 7).
FIG. 6
BEVEL
ADJUSTMENT
KNOB
FOOT
90°
BLADE
-11-
FIG. 7
TAB

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1661

Tabla de contenido