Publicidad
Idiomas disponibles
Idiomas disponibles
Carry out the connection of the device to the controller / other mod-
ules in the order described below:
1. Connect the data cable (S-Bus, ) to the controller . If necessary, extend the
cable using a 2-wire cable (bell wire).
2. Connect the device to the mains by means of the mains adapter .
3. For a direct connection to a router, connect the device to a router using
the network cable (included with the device, ). Alternatively use the WLAN
connection.
www
3.3
(W)LAN connection
The device can be connected to a router by using a network cable (CAT5e, RJ45
or similar) or via WLAN (see chap. 4.2 on page 28).
Î Connect the network cable included to the LAN connector of the router and
to the LAN connector of the device.
The LAN connector is located on the front side of the device and supports trans-
fer rates of up to 100 MBit per second.
27
Publicidad
