Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS
CONNECTIONS
Choosing a Connection
The following shows examples of connections commonly used to connect the DVD player with a TV and
other components.
Before Connecting the DVD Player
- Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.
- Refer to the user's manual of the additional components you are connecting for more information on those
particular components.
Connection to a TV (For Video)
1
Using component video cables (not included), connect the
VIDEO OUT on the rear of the DVD player to the VIDEO
IN terminal of TV.
2
Turn on the DVD player and TV.
3
Press the TV/VIDEO button on the TV's remote
control to select Video.
Note
- Noise may be generated if the audio cable is too close to the power cable.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 12 to 13)
- The number and position of terminals can vary depending on your TV set. Please refer to the user's man-
ual of the TV.
- If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the
DVD player.
- If you press the VIDEO SEL. button when DVD Player is in stop mode or no disc is inserted, the Video
Output mode changes in the following sequence: (I-SCAN ➝ P-SCAN).
WHITE
RED
YELLOW
Video Cable
Audio Cable
RED
YELLOW
WHITE
9
Publicidad
