Motorola Solutions EVX-261 Manual De Funcionamiento página 9

Battery Pack Installation and Removal
r To install the battery pack, align the battery pack to the
radio with an offset about 1/2 inch (1.5 cm) from the
top edge of battery compartment, then slide the battery
pack upward until it locks in place with a "Click."
r To remove the battery, turn the radio off and remove
any protective cases. Slide the Battery Pack Latch on
the bottom of the radio toward the front panel while
sliding the battery down about 1/2 inch (1.5 cm). Then
lift the battery out from the radio.
Do not attempt to open any of the rechargeable
Lithium-Ion packs, as they could explode if ac-
cidentally short-circuited.
EVX-261 O M
pErating
b
eFore
anual
y b
ou egin
Battery Charging
r Remove the Spacer Plate from the nest of the optional
CD-58 Desktop Charger, if the Battery Spacer is in-
stalled.
r Insert the DC plug from the optional PA-55 AC
Adapter into the DC jack on the rear panel of the op-
tional CD-58 Desktop Charger, and then connect the
PA-55 AC Adapter to the AC line outlet.
r Insert the battery pack into the CD-58 Desktop Char-
ger while aligning the slots of the battery pack with the
guides in the nest of the CD-58; refer to the follow-
ing illustration for details on proper positioning of the
battery pack. If charging with the transceiver attached,
turn the transceiver off. The antenna jack should be at
Turn the transceiver off,
if charging with the trans-
ceiver attached.
Spacer Plate
CD-58
AC Line Outlet
PA-55
7