Zycoo SC10 Guía De Instalación Rápida página 4

Network Settings
1
Connect the PoE+ cable ornetwork cable and power supply to the device. Wait for the
device to start up.
2
Then, remove the grille and press the button on the device. This will cause the device to
broadcast its IP address.
3
If you want to restore the device to its factory settings, press and hold the button for 10
seconds and then release it. The device will then restore its factory settings, and DHCP in
default. If the device does not obtain an IP address through DHCP, the default IP address is
192.168.1.101.
4
To access the device's login interface, enter the device's IP address (either the one
obtained through DHCP or the default IP address) directly into the address bar of a web
browser.
5
The default username and password for the device are both "admin".
Inte aces and Instructions
*Wire harness passes under cover
2
Network Ceiling Speaker
Model :SC10
Input: 12V 2A PoE: IEEE 802.3 at(42.5-57V
30W)
IP: DHCP
Username: admin
Password: admin