PowerWalker LiFe Battery System 48-100 Manual De Instrucciones página 18

floor first, then drill two holes on the wall. If there is one more
battery module to be stacked up, drill two holes at a vertical
distance of 420 mm.
(b) Push four expansion bolts into the Ø 13 mm holes drilled on the
previous step.
(c) Remove the nut, spring washer and flat washer.
(d) Take assembled battery module (in step 1) and put on the ground.
Align the hole on fixing plate with the two expansion bolts on the
ground. Align the hole on L-type bracket with two expansion bolts
on the wall. Pass through the remaining bolt in the floor and wall.
Then, screw back the nut, spring washer, and flat washeremove
nut, spring washer and flat washer.
15