Beurer HK 41 Instrucciones Para El Uso página 14

4. Operation
4.1 Safety
CAUTION
• The heating pad is fitted with a SAFETY SYSTEM. This sensor technology provides protection against
overheating across the entire surface of the heating pad with an automatic switch­off in the event
of a fault. If the SAFETY SYSTEM has switched off the heating pad, the temperature settings are
no longer illuminated when switched on.
• Please note that for safety reasons, the heating pad can no longer be operated after a fault has
occurred and must be sent to the specified service address.
• Do not connect the defective heat pad with another control of the same type. This would trigger a
permanent switch­off via the control's safety system.
4.2 Initial use
CAUTION
Ensure that the heating pad will not bunch up or become folded during use.
• To operate the heating pad connect the control to the heating pad by
plugging in the connector.
• Then plug in the power plug into the mains outlet.
4.3 Switching on
To switch the heating pad on, set the slider for ON/OFF and temperature settings to setting 1, 2 or 3.
The temperature settings are illuminated when switched on.
4.4 Setting the temperature
Level 0: OFF
Level 1: minimum heat
Level 2: medium heat
Level 3: maximum heat
NOTE:
The fastest way to warm up the heating pad is to initially set the highest temperature setting.
NOTE:
These heating pads have a fast heating function, which allows the pad to warm up faster
in the first 10 minutes.
WARNING
If the heating pad is being used over several hours, we recommend that
you set the lowest temperature setting on the control to avoid overheating
the heated body part, which may lead to burns to the skin.
4.5 Automatic switch-off
This heating pad is equipped with an automatic switch­off function. This turns off the heat sup­
ply approx. 90 minutes after the initial use of the heating pad. The temperature setting display
then starts to flash. So that the heating pad can be switched back on, the slider for ON/OFF
and temperature settings (5) must first be set to setting "0" (OFF). After about 5 seconds it is
possible to switch it on again.
14
90
min
STOP