Worx WX252 Manual Original página 13

Maintain this tool in accordance with these instructions and keep well
lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration and noise
accessories.
Plan your work schedule to spread any high vibration tool use across a number
of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
The power tool is intended for driving in and loosening screws as well as for
drilling in wood, metal and plastic.
ACTION
BEFORE OPERATION
Charging the Battery
NOTE:
1. Maximize Battery Performance Prior to initial use, the
battery must be charged 5 hours to fully utilize the battery
capacity.
2. When the battery is full charged, the light turns green.
ASSEMBLY AND ADJUSTMENT
Selecting the Proper Bit
Inserting and Removing bits
Forward/reverse/lock
WARNING: Never change the direction of rotation
when the chuck is rotating, wait until it is stopped!
Adjust the Extended Shaft Position
OPERATION
Operating the On/Off Switch
WARNING: Do not operate for long periods at low
speed because excess heat will be produced
internally.
LED Light Indicator
FIGURE
See Fig. A
See Fig. B
See Fig. C
See Fig. D1, D2, D3
See Fig. E, F
See Fig. G
See Fig. G
EN
13