Worx WX252 Manual Original página 14

MAINTENANCE
Your power tool requires no additional lubrication or maintenance. There is no
user serviceable parts in your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks flashing in the ventilation slots, this
is normal and will not damage your power tool.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or
retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage of tool and battery is
0℃-45℃.
The recommended ambient temperature range for the charging system during
charging is 0℃-40℃.
EN
14
TROUBLE SHOOTING
Problem
Battery will not
charge
Switch cannot be
pressed
XTD Driver stops
during driving
screws
Possible cause
1. Charger not
plugged into a
working outlet.
2. Surrounding air
temperature is too
hot or too cold
Forward/Reverse
switch at middle
position
XTD Driver battery is
out of power
Solution
1. Plug charger into a working outlet.
Check current by plugging in a lamp.
2. Move charger to an appropriate
place which temperature is suitable
for the charger.
Make sure switch is on Forward
or Reverse rotation according to
project need.
Make sure XTD Driver is fully charged
before using it.