Publicidad
Idiomas disponibles
Idiomas disponibles
16 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
16.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
16.2 Fault indications and rectification of faults
The following table assists in localizing and rectifying minor faults.
Fault
Your device is not cold
enough or it does not reach
the adjusted temperature:
The light does not work.
Vibrations & too much noise
& door does not close
properly
LED could not display.
LED display error – Lo
Buttons are not functional
Compressor will not start
Dew on the surface of
cabinet
Liquid sound
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
Defrost the device.
Contact customer service.
Check to assure that the wine refrigerator is level. Check
the fan. Components are loose. Device touches the wall.
The door is reversed and not properly installed.
The seal is weak. The shelves are out of position.
Contact customer service.
Room temperature is lower than desired temperature.
The surface of wine cabinet especially the glass door
appear some frost if item in a damp room.
This is due to the moisture in the air coming into contact
with the cabinet. Please wipe it away with dry cloth.
1) The sound of compressor when starts or stops
working
2) The flowing sound of refrigerant in the refrigeration
system
3) The evaporating sound of refrigerant in the evaporator
Possible Cause
36
Publicidad
