EAS ELECTRIC EMC186AZDX Manual De Instrucciones página 74

1.2 Installation warnings
Before using your fridge freezer for
the first time, please pay attention to
the following points:
• The operating voltage for your fridge
freezer is 220-240 V at 50Hz.
• The plug must be accessible after
installation.
• Your fridge freezer may have an
odour when it is operated for the first
time. This is normal and the odour
will fade when your fridge freezer
starts to cool.
• Before connecting your fridge
freezer, ensure that the information
on the data plate (voltage and
connected load) matches that of the
mains electricity supply. If in doubt,
consult a qualified electrician.
• Insert the plug into a socket with an
efficient ground connection. If the
socket has no ground contact or the
plug does not match, we
recommend you consult a qualified
electrician for assistance.
• The appliance must be connected
with a properly installed fused socket.
The power supply (AC) and voltage at
the operating point must match with
the details on the name plate of the
appliance (the name plate is located
on the inside left of the appliance).
We do not accept responsibility for
any damages that occur due to
ungrounded usage.
• Place your fridge freezer where it will
not be exposed to direct sunlight.
• Your fridge freezer must never be
used outdoors or exposed to rain.
• Your appliance must be at least 50
cm away from stoves, gas ovens and
heater cores, and at least 5 cm away
from electrical ovens.
• If your fridge freezer is placed next to
a deep freezer, there must be at least
2 cm between them to prevent
humidity forming on the outer
surface.
• Do not cover the body or top of fridge
freezer with lace. This will affect the
performance of your fridge freezer.
• Clearance of at least 150 mm is required
at the top of your appliance. Do not place
anything on top of your appliance.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly before
use (see Cleaning and Maintenance).
• Before using your fridge freezer, wipe
all parts with a solution of warm water
and a teaspoon of sodium bicarbonate.
Then, rinse with clean water and dry.
Return all parts to the fridge freezer
after cleaning.
• Use the adjustable front legs to make
sure your appliance is level and stable.
You can adjust the legs by turning
them in either direction. This must be
done before placing food in the
appliance.
• Install the two plastic distance guides
(the parts on the black
vanes -condenser- at the
rear) by turning it 90° (as
shown in the figure) to
prevent the condenser
from touching the wall.
• The distance between
the appliance and back wall must be a
maximum of 75 mm.
1.3 During Usage
• Do not connect your fridge freezer to
the mains electricity supply using an
extension lead.
• Do not use damaged, torn or old plugs.
• Do not pull, bend or damage the cord.
• Do not use plug adapter.
• This appliance is designed for use by
adults. Do not allow children to play
with the appliance or hang off the door.
• Never touch the power cord/plug with
wet hands. This may cause a short
circuit or electric shock.
• Do not place glass bottles or cans in the
ice-making compartment as they will
burst when the contents freeze.
EN - 74
V.2