Hilti SF 10W A22 Manual De Instrucciones Original página 24

Total vibration
Vibration emission value for screwdriving (a
Uncertainty for screwdriving (K)
Drilling in metal (a )
h,D
Uncertainty for drilling in metal (K)
5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.2 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.3 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.4 Fitting the side handle
CAUTION
Risk of injury by accidental starting!
▶ Make sure that the forward / reverse switch is in the middle position (switch-on interlock engaged) or that
the battery has been removed from the drill / driver.
▶ Fit the side handle.
5.5 Adjusting the side handle
▶ Adjust the side handle to the desired position.
5.6 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool in the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
20 English
)
h
2
3
SF 10W-A22
< 2.5 m/s²
1.5 m/s²
< 2.5 m/s²
1.5 m/s²
2130485
*2130485*