Efco DS 2400 D-PU Manual De Uso Y Mantenimiento página 20

articles including
trousers, gloves, safety spectacles, ear
protection and protective helmet. Work
clothing should be close-fitting but
comfortable.
3 - Use of the power unit is restricted to adult
operators capable of understanding and
complying with the safety rules, precautions
and operating instructions given in this
manual. Do not allow minors to use the
power unit under any circumstances.
4 - Ensure you are at a safe distance from other
persons or animals before using the power
unit.
5 - Before starting the power unit make sure
the throttle trigger is free moving.
6 - Fill the fuel tank away from heat sources and
with the engine stopped. Do not smoke
when refueling.
7 - Do not refuel the engine in an enclosed
place or poorly ventilated areas.
8 - Do not start the engine unless all engine
parts are fitted, including the exhaust
system, air filter, filter covers and starter
guard, and only when all parts are securely
fixed in place.
9 - When the engine is idling the coupled
attachment must be stopped. If the
attachment is running, adjust the idle speed
screw.
10 - Never attempt to perform maintenance
work when the engine is running.
11 - Do not use the engine if the exhaust system
is damaged.
12 - Do not use fuel (2-stroke mixture) to clean
the product.
13 - Keep the spark plug well clear of the spark
plug bore in the cylinder when checking the
spark.
14 - Check the power unit daily to ensure that all
safety and other devices are perfectly
functional.
15 - Do not use the power unit in enclosed or
poorly ventilated places. Exhaust gas is
toxic: contains carbon monoxide.
16 - When the power unit is running (of when it
is stopped but still hot) keep it well away
from inflammable materials.
boots, heavy-duty 17 - Beware of the hot exhaust system and other
hot engine parts.
18 - Stop the power unit and wait for it to cool
down before refueling. Do not fill the fuel
tank completely.
19 - Do not remove the fuel cap or fill the tank
while the engine is still hot or when it is
running (allow the engine to cool for at least
2 minutes before refueling).
20 - Do not run the engine in the presence of
fuel spills, perceptible petrol odour or
explosion hazards (move the power tool
away from any fuel spills and avoid the
creation of sparks until the fuel has
completely evaporated).
21 - Do not tamper with the engine settings (run
the power unit at the speed preset by the
manufacturer).
22 - Empty the fuel tank before transporting the
power unit over rough road surfaces or long
distances.
23 - Store the power unit in a dry place well
away from sources of heat and raised off the
ground.
24 - If necessary, the flywheel and clutch must
always be repaired by an Authorised Service
Centre to avoid the risk of breakages
resulting in hazardous projection of objects.
25 - Do not attempt to carry out any servicing or
repairs other than normal maintenance
yourself. Refer exclusively to an Authorised
Service Centre.
26 - Please note that the owner or the user is
responsible for any accidents or damage to
third parties or their property.
WARNING
- With the engine running, always hold the
front grip with the left hand and the rear
grip with the right hand. Never use a cross-
handed grip. Left-handers should follow
these instructions too (Fig. 2). Check that all
parts of the body are kept away from the
blades and muffler.
- Never use a machine with faulty safety
e q u i p m e n t . T h e m a c h i n e ' s s a f e t y
e q u i p m e n t m u s t b e c h e c k e d a n d
maintained as described in this section. If
GB
17