Publicidad
Warnings
Fault detection signal:
Temperature at thermal switch > 100°C (± 5 K)
a)
UaS = Low *
Output signals remain available
LED failure or contamination of the graduated disk
b)
UaS = Low (min. 20 ms)
Output signals at high impedance **
c)
d)
Attention: A temperature at the thermo switch of > 110° C (± 5 K) switches off the supply voltage.**
* The fault-detection signal is not reset until after the rotary encoder has cooled.
** Operation with position feedback is then no longer possible.
6
U
aS
TTL
/
/
U
U
= High:
aS
aS
HTL
U
< 8 V
P
UaS = Low
Output signals at high impedance **
Temperature overload of cable driver
UaS = Low *
Output signals at high impedance **
= Low:
1 V
SS
/
/
/
Publicidad
